Powr-Flite PFX3S Use and Care Manual download pdf (Page 7)

SAVE THESE INSTRUCTIONS

DAILY / INTERVAL

1) The filter in the solution tank (FIG 3) should be kept clean. It can be removed if

necessary. A damaged filter should be replaced otherwise blockages and/or

damage to the pump head and spray jet can occur.

2) Check the spray jet (FIG 4) for blockage and a uniform spray pattern .

Remove jet and blow through to clean. Do not use a pin as this may cause

damage to the jet.

3) Check and remove any debris or lint build-up from the vacuum head, brush,

and brush housing.

4) Always wash out the tanks with clean water after use. To do this, pour clean

water into the solution tank and spray through spray tip to clear chemical

residue from the pump, lines, and spray tip. Allow the vacuum to run for a few

minutes after use to aid the machine in drying out and to help prevent bacteria

and odors.

WEEKLY

1) Inspect hoses (unseen blockages sometimes occur), hose cuffs, and the rubber seal on the recovery tank lid. The

main cable, plug, and switches should also be examined for damage.

NOTE: It is advisable to store the unit with the recovery tank lid removed.

CAUTION: THIS UNIT MUST BE PROTECTED FROM FREEZING. Damage from freezing could cause machine to malfunction.

GENERAL INSTRUCTIONSGENERAL INSTRUCTIONS

ROUTINE MAINTENANCE INSTRUCTIONSROUTINE MAINTENANCE INSTRUCTIONS

STORAGE

WHEN CLEANING IS FINISHED:

1) Connect the drain hose (clipped to the handle) to the solution fitting at the

back of the machine and place the other end into the waste tank, turn on

the accessory switch. (FIG 1C) This will pump the remaining solution into

the waste tank for easy drainage.

2) To disconnect the solution hose, push in on the ring of the solution fitting.

(FIG 2) Switch off the machine, remove power plug from the socket, and

empty the waste tank. Leave waste tank open when storing.

3) Raise the brush to storage position.

ACCESSORIES / TOOLS (OPTIONAL)

For upholstery cleaning and inaccessible areas. Remove the white cuff from the transparent cover (FIG 1A) and con-

nect the accessory vacuum hose in its place. Connect the accessory solution hose to the solution fitting at the back of

the machine by pushing back the locking ring to fit. (FIG 2) Then press vacuum switch & press the accessory/brush

switch to the left (FIG 1C)and the wand or upholstery tool can now be used.

FIG. 2

FIG. 3

FIG. 4

SOLUTION

SPRAY

JET

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Powr-Flite PFX3S Use and Care Manual Page 7

Comments to this Manuals

Related products and manuals for Scrubber Powr-Flite PFX3S